Briggs & Stratton CLEANSHOT 2050PSI - Manual (Page 9)

CleanShot™ 2050 PSI Pressure Washer
9
2. Point nozzle down towards a firm surface and press
trigger to test pattern (Figure 7).
3. Twisting nozzle adjusts spray pattern from a narrow
pattern to a fan pattern (Figure 8).
4. For most effective cleaning, keep spray nozzle from
8 to 24 inches away from cleaning surface.
5. If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
6. DO NOT get closer than 6 inches when cleaning tires.
Using the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.The high pressure spray is most
effective when the tip of the nozzle extension is held
between 8 to 24 inches from the surface being cleaned.
To attach the turbo nozzle to the spray gun:
1. Engage safety latch to spray gun trigger.
2. Remove the nozzle extension from the spray gun, if
attached.
3. Attach the turbo nozzle extension to spray gun
(Figure 9).Tighten by hand.
4. Disengage safety latch to spray gun trigger.
5. Always start the turbo nozzle at a distance, gradually
getting closer to the surface until you get the cleaning
force you want.
NOTE: Detergent cannot be applied with turbo nozzle.
Using the Utility Brush
The utility brush allows you to scrub surfaces with water
filtering through the bristles.
To attach the utility brush to the spray gun:
1. Engage safety latch to spray gun trigger.
2. Tighten the adapter to the brush base.
3. Remove the nozzle extension from the spray gun, if
attached.
Slide nozzle backward
for High Pressure
Mode
Slide nozzle forward for low
pressure mode and
detergent application
Figure 6 — Adjusting Nozzle for Pressure
Figure 7 — Testing the Spray Pattern
Figure 8 — Adjusting the Nozzle for Spray Pattern
Rotate nozzle
counterclockwise for fan
spray pattern
Rotate nozzle clockwise
for narrow spray pattern
CAUTION
• Always make sure the surface you will clean will not be
damaged by the high pressure spray by testing in a hidden area.
The turbo nozzle produces an extremely high pressure
spray which is capable of removing paint and cutting
holes through surfaces if held too close.
Figure 9 — Connect Turbo Nozzle Extension to Spray Gun