Philips HAIRCLIPPER Series 1000 Cortapelos - Manual (Page 8)

Optimising the lifetime of the rechargeable battery
- After you have charged the appliance for the first time, do not
recharge it between clipping sessions. Continue using it and recharge
it only when the battery is (almost) empty.
- Discharge the battery completely twice a year by letting the motor
run until it stops.
- Do not keep the appliance plugged in continuously.
- If you have not used the appliance for a long time, recharge it for 12
hours.
Using the appliance
Clipping with comb attachment
Select the small or large comb attachment, depending on the desired hair
length.
Hair length settings:
- The hair length settings are indicated in millimetres on the arms of
the comb attachment. The settings correspond to the remaining hair
length after cutting (Fig. 2).
- The small comb attachment cuts hair to a length of 3mm, 6mm, 9mm,
12mm, 15mm, 18mm or 21mm.
- The large comb attachment cuts the hair to a length of 23mm, 26mm,
29mm, 32mm, 35mm, 38mm or 41mm.
1 Slide the arms of the comb attachment into the guiding grooves of
the appliance (‘click’) (Fig. 3).
2 To set the comb attachment to the desired hair length, turn the
hair length adjustment ring to the right or to the left (Fig. 4).
3 Switch on the appliance.
Tips
- We advise you to start clipping at the highest setting of the large
comb attachment and to reduce the hair length in small steps until
you reach the desired hair length.
- If a lot of hair has accumulated in the comb attachment, remove the
comb attachment and blow and/or shake the hair out of it. Removing
English 8