Beko D2 7082 E - Manual (Page 22)

TR 22
on the screen whenever any button
is pressed while the machine is child-
locked.
To deactivate the child-proof lock,
press the 2nd and 4th auxiliary function
buttons for 3 sec.
“C:OFF” (Child lock is deactivated) label
appears on the screen.
Ending the program through
canceling
“Start/Pause/Cancel” button (Figure
2-8) is pressed for 3 seconds to cancel
the program. Start symbol (Figure
3-2j) will flash during cancellation.
After cancellation, the symbol of the
corresponding step at which the
cancellation was made will remain lit and
“End” label will appear on the screen.
Program in rinse hold mode
• This process is shown with the
flashing Spin Symbol (Figure 3-2c)
and the lit up Standby Symbol
(Figure 3-2k).
If you wish to spin when the machine is
in this mode:
Adjust the spin speed. Press “Start/
Pause/Cancel” button (Figure 2-8).
The program continues, pumps out
the water and spins. Standby Symbol
(Figure 3-2k) fades out and Start Symbol
(Figure 3-2j) lights up.
If you want to discharge the water only
without spinning:
Press “Start/Pause/Cancel” button
(Figure 2-8). Standby symbol (Figure
3-2k) will fade. Start symbol (Figure 3-2j)
will light up. The program continues and
only pumps out the water.
End of program
When the program is finished, the
symbols of the relevant steps will remain
lit up and the auxiliary function, spin and
temperature data selected at the start-
up of the program will remain selected.
“End” label will appear on the screen.