BT 75 - Manual (Page 15)

Your BT Response 75
announces the current ring
delay and the message counter
displays the selected answer
delay setting.
Keep holding the Skip
ᮣ
button. Your BT Response 75
announces and displays the
answer delay options.
When you hear your desired
setting, release the Skip
ᮣ
button. After 2 seconds your
BT Response 75 will announce
the new answer delay setting
and then return to ‘Answer On’
mode. The setting will be shown
on the display.
13
BT Response 75 – Issue 2 – Edition 1 – 7/10/03
Receiving messages
To receive incoming messages
After following the set-up procedure
your BT Response 75 is ready to
receive messages.
To check the answer delay
setting
Press the Skip
ᮣ
button.
You BT Response 75 will
announce the current ring
delay setting and show the
setting on the display.
Skip
ᮣ
Your BT Response 75 will
automatically record an
incoming message when it
is connected to your phone
socket and is set to
‘Answer On’.
When your BT Response 75
has received new messages
(or memos) it will beep (see
‘Audible Message Alert to switch
off ’)
and the display will show
the number of messages
received. If you have more
than 9 messages, the display
will flash 9.
If the memory is full then it will
announce, “Memory full, thank
you for calling”
and disconnect
the line.
Your BT Response 75 can
record up to 30 messages and
memos, within a total
recording time
of 36 minutes. If the memory
capacity is full, the display will
flash F and your answering
machine will not record further
messages.
Please note
Two minutes is the maximum time
allowed for each incoming message.
If the maximum message length is
reached, your BT Response 75 will
announce, “Thank you for calling”
and disconnect the line.