Britax BOULEVARD CS User Manual
Page 20
36
37
Cover Removal
Remove the infant body pillow.
1
Loosen the harness by lifting the harness
2
adjuster lever while pulling both shoulder
straps forward as far as possible.
Release the chest clip and unbuckle the
3
harness.
Unhook the shoulder straps from the
4
harness yoke on the rear of the child seat
(Fig. A).
Pull the upper harness straps through the
5
head restraint and cover to the front of the
child seat.
Recline the child seat.
6
Locate the metal buckle strap retainer on the
7
bottom of the child seat.
Pull the retainer away from the child seat to
8
loosen.
Turn the retainer so the short side will fit through the slot in the child
9
seat shell (Fig. B).
Push the retainer through the slots in the shell and cover, to the top
10
of the child seat.
Remove the head restraint portion of the cover. Remove the energy-
11
absorbing foam from the head restraint and set aside.
Be careful not to damage the energy-absorbing foam.
*
Gently remove the upper portion of the cover by pulling it from
12
behind the side air cushions and then around the head restraint.
Pull the lower harness straps, buckle tongues, HUGS
13
™
chest pads,
and chest clip through the lower slots in cover.
Remove the entire cover from the child seat.
14
Cleaning the Cover
HAND WASH using cold water and mild soap.
•
LINE or LIE-FLAT DRY to prevent the cover from shrinking.
•
DO NOT
•
bleach, machine wash, machine dry or iron.
Refitting the Cover
To refit the cover, reverse the directions on page 36. Make sure that the
shoulder straps are not twisted, and are properly threaded through the
chest clip, HUGS
TM
chest pads, cover, foam, and shell.
Cleaning the Shell
SPONGE CLEAN using warm water and mild soap.
•
TOWEL DRY
•
DO NOT
•
use solvents or abrasive cleaners.
Cleaning the Harness
SPONGE CLEAN using warm water and mild soap.
•
TOWEL DRY
•
DO NOT
•
bleach, machine wash, machine dry, iron, or disassemble
the harness.
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it is clean and free of
food, drink or other debris. If debris is present, it must be removed to
prevent interference with the adjuster mechanism.
BRUSH AWAY LOOSE DEBRIS using a soft-bristled brush.
•
SPONGE CLEAN using warm water and a mild soap.
•
TOWEL DRY
•
DO NOT
•
use solvents, abrasive cleaners or disassemble the harness.
a
b
Care and Maintenance
Care and Maintenance