Blaupunkt ACD 9430 - Manual (Page 7)

ACD 9430
16
Balance and Fader Control
Balance control
To balance the sound level left/right:
•
Press the AUD button 2 until bal is
shown on the display.
Press rocker switch
7 on the left
or right to adjust the sound impression
according to your personal preferences.
Display
9 gives you a number bet-
ween -9 and +9.
Fader control
To balance the front/rear sound level:
•
Press the AUD button 2 until fad is
shown on the display.
Press rocker switch
7 on the left
or right to adjust the sound impression
according to your personal preferences.
Display
9 gives you a number bet-
ween -9 and +9.
Note:
If the rocker switch < > is kept depressed (on
the left or right), the set quickly advances to
the final values (+7/+9 or -7/-9) or to the “0”
position.
Radio Section
Selecting a Station
With your car radio you can select stations
from the FM (ultra-short wave) and FM-Tra-
velstore level.
To select FM,
• press the FM•T button 3 briefly. “FM”
lights up on display 9 a.
To select FM-Travelstore,
•
press the FM•T button 3 briefly until
“FM•T” is shown on display 9 b.
For more information on this function
see chapter “Automatically Storing the
Strongest Stations”.
Tuning in a Station Automatical-
ly
Tuning in the following station
•
Press the rocker switch 7 on the
right. The car stereo automatically
starts searching for the next station.
Tuning in the previous station
• Press the rocker switch 7 on the
left. The car stereo automatically starts
searching for the previous station.
If the rocker switch
7 is kept de-
pressed on the right or the left, the sta-
tion seek operation continues to be
carried out quickly in the corresponding
direction.
Manual Tuning
To manually tune in a station,
•
press the lo•m button 5 until “m” lights
up on display 9 f.
You can now manually search for the desired
stations via the buttons
7 .
Adjusting the Station Seek
Sensitivity
With this set you can modify the automatic
station seek sensitivity in all wavebands.
If you want to search for strong stations only
(reduced sensitivity):
•
Press the lo button 5 until “lo” lights
up on display 9 e.
If you also want to search for weaker stations
(increased sensitivity):
•
Press the lo button 5 once again; the
“lo” indication on display 9 e goes out.
Mono/Stereo Operation
If the lo•m button 5 is pressed longer than
2 secs. but less than 8 secs., the set swit-
ches over to mono and the stereo symbol (h)
goes off.
If the lo•m button
5 is pressed longer than