Bravetti F2015HR - Manual (Page 5)

Using Solid Fat
Warning: Do Not put solid shortening in
the oil container or the frying basket.
• If using solid vegetable shortening, melt
it first in a separate pan and then very
carefully pour the melted fat into the oil
container.
• Previously used solid vegetable shortening
which has curdled and hardened in the oil
container should be removed from the oil
container and melted in a separate pan
before reusing.
OPERATING INSTRUCTIONS
• Hold the control panel with the heating
element in your hand.
• Slide the control panel down making
sure that the control panel is fully
seated into the power junction module.
(Fig. 4)
Important Notice: The Automatic
Safety Switch ensures that the unit will
not operate unless the Control Panel has
been seated properly into the power
junction module. This is not a defect. This
product is fitted with a safety switch to
prevent the unit from turning on
accidentally.
Control Panel
Installing the “Control Panel With
the Heating Element” Into Place
4
• Use blended vegetable oil, pure corn oil
or canola oil. Do not use olive oil,
margarine, lard or drippings.
• The oil level must always be maintained
between the minimum (10 cups/2.4 L.)
and the maximum (12.5 cups/3.0 L.)
levels marked inside the oil container.
Check the oil level before each use. For
best results, keep the oil close to the
maximum level. (Fig. 3)
• Never mix different oils and fats together.
Do not mix old and new oil.
Filling the Oil Container
Never plug in the Deep Fryer before filling
with oil to specified level. Always make
sure control panel is securely in place in
the body and the heating element is
inside the oil in the container before
plugging in.
Fig. 3
Heating Element
Power Junction
Module
Fig. 4
Oil level
indicator
OPERATION INSTRUCTIONS
• Make sure the Deep Fryer is unplugged
and the oil has cooled (approximately 2
hours) before attempting to clean or
store the Deep Fryer.
• The oil does not need to be changed
after each use. We do not recommend
storing and reusing oil that was used for
frying high protein foods such as
poultry, fish or other meats. When oil is
mainly used to fry potatoes and is
filtered after each use, it can be used 8
to 10 times. However, do not use the
same oil for longer than 6 months.
• To filter the oil, first make sure the oil
has cooled and then empty the oil
from the Oil Container into a storage
container or bottle. (Fig. 6) Wash and
dry the Oil Container and basket. To
reuse, refill the Oil Container with
the oil, pouring the oil through a wire
strainer or paper filter. (Fig. 7)
Storing used oil
Fig. 6
Filtering used oil
Fig. 7
To Store or Reuse Cooking Oil
The following cooking times reflect only the
approximate time needed to fry one basket
1/2 full. The exact time may be different
depending on actual quantity, personal
cooking preferences, size and thickness of
pieces, etc. In general, use lower settings
for delicate foods (vegetables, fish) and
higher settings for frozen foods, French
Fries and Chicken.
Suggested Temperature Settings
Food Cooking Time Temp.
French Fries 6-9 minutes 375 °F
Fish Fillets 3-5 minutes 320 °F
Chicken
Fingers
6-8 minutes 350 °F
Chicken
Pieces
13-20 minutes 350 °F
Fried Zucchini 3 minutes 320 °F
Fried
Mushrooms
3 minutes 320 °F
Onion Rings 3 minutes 320 °F
Donuts 3-5 minutes 350 °F
Apple
Beignets
4 minutes 350 °F
Shrimp 4-6 minutes 320 °F
7
Detachable Power Cord
Your Deep Fryer has been specifically
designed with your safety in mind. This
deep fryer has ia unique detachable power
supply cord. This power supply cord cord
is designed to “Break Away” from the fryer
body in the event that the supply cord is
inadvertently pulled. This is intended to
prevent the tipping of the appliance and
hazardous spillage of hot oil.
The female receptacle portion of the power
supply cord is permanently attached to the
rear of the the control panel.
To connect the male power cord plug to
the female receptacle on the appliance,
orient the male plug so that it mates with
the female receptacle. The male plug can
only be inserted one way. If the male plug
will not go into the receptacle on the
appliance, rotate the male plug 180°.
IMPORTANT: Should the male plug
become detached from the appliance
during use, it is important to:
1. Unplug the power cord from the wall
outlet.
2. Turn off the appliance
at the control panel.
3. Re-attach the power
cord to the appliance.
4. Re-connect to power
outlet.
5. Turn the appliance
back on.
• Allow the deep fryer to cool completely.
• Remove the control panel from the
unit.
• Push the thermostat reset button
located on the back of the control
panel with the back of a ball point
pen. (Fig. 8) The unit will beep to
indicate that it has re-set.
If for some reason the deep fryer stops
heating, the reason might be that the
safety reset switch has disconnected. To
reconnect the deep fryer, follow the
instructions below:
How To Reset the Deep Fryer
Fig. 8
Thermostat
Reset Button