beautypg.com

Select cycle, Select options, Pull control dial out to start – Whirlpool 6800 User Manual

Page 9: Step 4 step 5 step 6

background image

8

STEP

4

STEP

5

STEP

6

Control features vary by model.

Select Cycle

To select a cycle, push the control dial IN and turn it to
the right (clockwise) until the pointer is at the soil level
needed for the wash load.

Permanent Press/Delicates Cycles

Permanent Press/Delicates cycles share the same
portion of the control dial. For permanent press fabrics,
select the cycle and turn the Fabric Selection dial to
Perm. Press. For delicate loads select Delicate.

Regular Cycle

This cycle provides up to 16 minutes of agitation.
Select the Regular Fabric Selection.

Soak Only

(select models)

Provides 4 minutes of agitation, then soak. Avoid
extended soaking – soak for 30 minutes or less.
The control dial must be manually advanced to a spin
setting to spin and drain the water.

(if desired)

Select Options

Extra Rinse

When the switch is in the “On” position, an additional
rinse at the end of the Regular and Permanent Press
cycles is provided to more completely remove laundry
additives, suds, perfumes, etc.

End of Cycle Signal

The end of cycle signal will sound once the cycle is
completed. The end of cycle signal can be canceled by
setting the switch to off.

Pull Control Dial Out to Start

You may stop the washer at any time by simply
pushing the control dial IN. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed IN (off position) when you change the setting.

Note

• Do not attempt to turn the control dial

counterclockwise. Damage to the timer will result.

See Laundering Tips for proper washing procedures,
stain removal, and special laundering situations.