Whirlpool WRS965CIAM - Manual (Page 8)

8
5. With the side trims properly seated in the lower trim, slide
each trim into the door panel groove.
6. Align the upper trim with the trim clips at the top of each side
trim.
7. Slide the upper trim into the door panel groove by applying
firm downward pressure. Be sure that the grooves on the
upper trim are properly aligned with the rivets on the door
panel.
8. When fully seated, the upper trim should be nearly flush with
the top of the freezer door, completely covering both side trim
clips.
9. Repeat the previous steps to install the refrigerator door
panel.
Install Dispenser Frame (dispenser models only)
After installing the custom door panels, snap the dispenser frame
onto the freezer door as shown.
Connect Water Supply
Read all directions before you begin.
IMPORTANT:
■ Plumbing shall be installed in accordance with the
International Plumbing Code and any local codes and
ordinances.
■ The gray water tubing on the back of the refrigerator (which is
used to connect to the household water line) is a PEX
(cross-linked polyethylene) tube. Copper and PEX tubing
connections from the household water line to the refrigerator
are acceptable, and will help avoid off-taste or odor in your ice
or water. Check for leaks.
If PEX tubing is used instead of copper, we recommend the
following Whirlpool Part Numbers:
W10505928RP (7 ft [2.14 m] jacketed PEX),
8212547RP (5 ft [1.52 m] PEX), or
W10267701RP (25 ft [7.62 m] PEX).
■ Install tubing only in areas where temperatures will remain
above freezing.
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
■ Flat-blade screwdriver
■
⁷⁄₁₆" and ¹⁄₂" open-end wrenches or two adjustable wrenches
■
¹⁄₄" nut driver
A. Trim clip
A