beautypg.com

Water filter certifications – Whirlpool WRS571CIDM User Manual

Page 19

background image

19

WATER FILTER CERTIFICATIONS

Water is leaking or
dripping from the
dispenser

NOTE: After dispensing, a few additional drops of water are normal.

Glass was not held under the dispenser long enough - Hold the glass under the dispenser for
2 to 3 seconds after releasing the dispenser pad/lever.

New installation, or water filter was recently installed or replaced - Air in the water lines causes the
water dispenser to drip. Flush the water system to remove the air in the water lines. See “Water and Ice
Dispensers” in the User Instructions or User Guide.

Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or
pieces.

Water is leaking
from the back of the
refrigerator

Water line connections are not fully tightened - Make sure all connections are firmly tightened. See
“Connect Water Supply.”

Water from the
dispenser is
not cool enough
(on some models)

NOTE: Water from the dispenser is chilled to 50°F (10°C).

New installation - Allow 24 hours after installation for the water supply to cool completely.

Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool
completely.

Water has not been recently dispensed - The first glass of water may not be cool. Discard the first
glass of water dispensed.

Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a cold
water pipe. See “Water Supply Requirements.”

ICE AND WATER

Possible Causes and/or Recommended Solutions