Special programmes – Neff V6320X0GB User Manual

Page 12

Special programmes

Fluff removal cycle

This programme is designed to clean the drying cycle of any fluff
deposits. After 10 drying cycles, the washer-dryer uses the symbol

Fluff removal cycle in the display panel to show that this programme

should be run. The electronic cycle counter is then automatically reset.
The

Fluff removal cycle symbol goes out after the programme starts.

To run the Fluff removal cycle programme, proceed as follows:

Make sure that the drum is completely empty and close the door.
Set the programme selector to

Fluff removal cycle.

Press the

Start/Pause button.

You can also run the Fluff removal cycle programme at any time without

prompting from the appliance.

Rinse + Spin

An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the

Drain + Spin

Drain the rinsing water following a programme with $ (Rinse stop)

Turn the programme selector to

Drain + Spin.

Set the spin speed to $

(Rinse stop).

Press the

Start/Pause button.

or
Drain and spin at the desired spin speed:

Turn the programme selector to

Drain + Spin.

Press the

Spin button repeatedly until the desired spin speed is set.

Press the

Start/Pause button.