Neff S51M53X1GB User Manual
Neff Washers
Table of contents
Document Outline
- 8 Intended use
- 1. Check the packaging and dishwasher immediately for damage caused in transit. Do not switch on a damaged appliance, but contact your supplier.
- 1. Make redundant appliances unusable to prevent subsequent accidents.
- ■ To prevent injuries, e.g. caused by stumbling, open the dishwasher only briefly in order to load and unload the dishwasher.
- ■ Knives and other utensils with sharp points must be placed in the cutlery basket with the points downwards or horizontally on the knife shelf*.
- ■ Do not lean or sit on the open door.
- ■ In the case of free-standing appliances, ensure that the baskets are not overloaded.
- ■ If the appliance is not in a cavity and a side panel is accessible, the door hinge area must be covered at the side for reasons of safety (risk of injury). The covers are available as optional accessories from customer service or specialist outlets.
- ■ If fitted, use the childproof lock. An exact description can be found in the back of the enve lope.
- ■ Do not allow children to play with or operate the appliance.
- ■ Keep children away from detergents and rinse aid. These may cause chemical burns in the mouth, throat and eyes or asphyxiation.
- ■ Keep children away from open dishwasher. The water in the rinsing compartment is not drinking water and could contain detergent residue.
- ■ Ensure that children do not place fingers in the tablet collecting tray 1:. Small fingers could become caught in the slots.
- ■ When opening and closing the door on an eye-level appliance, ensure that children do not become jammed or crushed between the appliance door and the cupboard door below.
- ■ Children could become locked in the appliance (danger of suffocation) or get into another dangerous situation.
- 7 Protection of the environment
- * Getting to know your appliance
- + Water softening system/Special salt
- 1. Find out about the hardness value of your tap water. Your water utility company will help you with this.
- 1. Press programme button 3.
- 1. Open the screw-type cap of the compartment 1R.
- 2. Fill the tank with water (only required when switching on the appliance for the first time).
- 3. Then add dishwasher salt (not table salt or tablets).
- Using detergents with salt componentDetergents with salt component
- Switching off salt refill indicator/water softening systemSwitching off water softening system
- , Rinse aid
- 1. Open the dispenser 9" by pressing and lifting the plate on the cover.
- 1. Open the door.
- 1. Press programme button 3.
- 1. Remove large food remnants. It is not necessary to prerinse utensils under running water.
- 2. Place the utensils so that
- Unloading the dishwasher
- Cups and glasses
- Pans
- Cutlery basket
- EtagereEtagere *
- Folding spikesFolding spikes *
- Small accessories holder *Small accessories holder
- Knife shelf *Knife shelf
- Adjusting the height of the basketAdjusting the height of the basket *
- Top basket with side levers
- 1. Pull out the top basket 1* out.
- 2. To lower the basket, press in the left and then the right lever on the outside of the basket. In doing so, hold the sides of the basket along the upper edge to prevent it from suddenly dropping.
- 3. To raise the basket, hold the basket on the sides of the upper edge and lift it up.
- 4. Before re-inserting the basket again, ensure that it is at the same height on both sides. Otherwise, the appliance door cannot be closed and the upper spray arm will not be connected to the water circuit.
- Top basket with upper and lower roller pairs
- 1. Pull out the top basket 1* out.
- 1. If the detergent dispenser 9* is still closed, press the lock 92 to open the detergent dispenser.
- / Overview of programmes
- Overview of programmes
- The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
- Programme selection
- Information for test institutes
- 0 Additional options
- 1 Operating the appliance
- 1. Turn on the tap fully.
- 1. Open the door.
- 1. By pressing the button 3, you can switch the function off ‚:‹‹ or on ‚:‹‚.
- 1. Open the door.
- 2. Switch on ON/OFF switch (.
- 3. Press button P + until the digital display h jumps to œ:‹‚.
- 4. Press P + or – button until the displayed time corresponds with your requirements.
- 5. Press START button `, timer programming is activated.
- 6. To delete timer programming, press the P + or – button until h œ:‹‹ is indicated on the digital display.
- 7. Close the door.
- End of programme
- 1. Open the door.
- 1. Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of ›:‹„ has been reached, the display jumps back to ›:‹‹ (off).
- 1. Open the door.
- 1. Press programme button 3.
- 1. Open the door.
- 1. Open the door.
- 1. Open the door.
- 1. Open the door.
- 1. Press the button 3 to switch the Intensive drying on š:‹‚ or off š:‹‹.
- 1. After each washing cycle check the filters for residue.
- 1. Check outlet nozzles on the spray arms for blockages.
- 1. First always disconnect the appliance from the power supply.
- 2. Take out top basket 1* and bottom basket 1j.
- 3. Remove the filters 1Z.
- 4. Scoop out water, use a sponge if required.
- 5. Prise out the white pump cover (as illustrated) using a spoon. Grip the cover on the crosspiece and lift diagonally inwards. Remove cover completely.
- 6. Check impeller wheel and remove any foreign objects.
- 7. Place cover in the original position and press down until it engages (click).
- 8. Install filters.
- 9. Re-insert baskets.
- Fault table
- 4 Customer service
- 5 Installation and connection
- 1. Checking appliance on delivery
- 1. The required work sequence can be found in the installation instructions. If required, fit a siphon with an drainage connection.
- 1. Fasten the drinking water connection to the tap according to the installation instructions using the enclosed parts.
- 1. Open the door.
- 1. By pressing the 3 button, you can switch the hot water setting off ‘:‹‹ or on ‘:‹‚.
- 1. Disconnect the appliance from the power supply.
- 1. Turn on the tap.
- 2. Open the door.
- 3. Switch on ON/OFF switch (.
- 4. Select programme with the highest temperature.
- 5. Press START button `.
- 6. Close the door.
- 7. Open door after approx. 4 minutes.
- 8. Press START button ` until ‹:‹‚ is indicated on the digital display.
- 9. Close the door.
- 10. Open door after approx. 1 minute.
- 11. Switch off ON/OFF switch (.
- 12. Turn off the tap, disconnect supply hose and drain water.
- Protection against frostProtection against frost (Emptying the appliance)