Bissell 82G7S - Manual (Page 13)

13
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
Replace drive belt
1. Unplug the vacuum from electrical outlet.
2. With the rotating floor brush removed
from the vacuum cleaner (Steps 1-4
of check rotating floor brush and drive
belt), grasp the old drive belt and
remove from the motor pulley. Discard
the old drive belt.
3. Place the new drive belt over the motor
pulley and loop other end over the
rotating floor brush in the space between
the bristles.
notE: It is important that you use only
genuine bISSEll replacement belts.
Generic belts may not meet the exact
specifications required to keep your
vacuum operating at its peak performance.
the use of unbranded belts could lead to
early failure of the vacuum and could void
your warranty.
4. Pull the rotating floor brush firmly into
position, stretching the drive belt and
place ends of the rotating floor brush
down into the slots on sides. Alignment
of brush ends in slots may be necessary
to fully insert the brush.
5. Turn the rotating floor brush by hand sev-
eral times. If properly installed, the drive
belt will center itself on the rotating brush
crown.
6. Insert front edge of brush cover, rotate
into place, and snap 3 latches.
Replace lightbulb
1.
Unplug the vacuum from electrical outlet.
2. Using a flat head screwdriver, pry the tab
on the left and right side out and pull out to
remove the lens.
3. Remove the bulb from the socket by
grasping the bulb and pulling gently. Install
the new bulb by pushing it gently into the
socket until the bulb snaps into place.
4. Reposition the lens and snap it back
into place.
3.
Motor Pulley
2.
3.
4.