Baby Trend 7311 - Manual (Page 11)

Cosco Designer 22
®
and Designer 35
®
Please follow the following instructions for proper installation of
your infant car seat.
Installation of the Cosco
®
Designer 22
®
and Designer
35
®
Infant Car Seat
1. Place front seat in the reclined position. With one hand grasp
the car seat handle (in its upright, carrying position) and gently
place the seat, so that the baby faces the rear of the stroller, onto
the Snap-N-Go attachment system so that the large groove on
the seat bottom rests on the Snap Bar.
2. Thread the two ends of the Car Seat Strap (attached to the Snap-
N-Go frame) through the seat belt slots on the sides of the car
seat, then snap the two buckles together (see Figure 2). The fi rst
time you do this, you will need to adjust the length of the strap
for a tight fi t around the car seat. FOR SAFE OPERATION,
IT IS VERY IMPORTANT THAT THE CAR SEAT STRAP
IS ALWAYS TIGHTLY FASTENED AROUND THE CAR
SEAT.
3. Test for secure installation by moving the car seat in all directions.
The car seat should be securely attached to the stroller.
Removal of the Cosco
®
Designer 22
®
and Designer 35
®
Infant Car Seat
1. Unlock the Car Seat Strap and remove both ends from the seat
belt slots on the side of the car seat.
2. With one hand, grasp the car seat handle (in its upright, carrying
position) and lift the car seat upward from the Snap-N-Go
attachment system.
Figure 1.
Figure 2.
Snap Bar
Position “I”
Position “5”
11
Cosco ® , Peg Perego ® , Primo Viaggio ® , Evenfl o ® , Cozy Carry ® , On my Way ® , Embrace ® ,
Century ® , Vante ® , Graco ® , Cosco ® Arriva ® and Snug Ride ® are the trademarks of their owners.
They are not associated with Baby Trend, Inc. and no approval or endorsement is implied.