Bradley Smoker WS-1X User Manual
Page 3
Installation
WS-1X
Bradley Corporation • 215-1441 Rev. C; EN 07-304
4/2/07
3
1
Rough-In Piping
Supply inlets are 1/2" NPT fl exible hose and are accessible from the back of the shower or from knockouts on the top cover.
Bradley’s Equa-Flo valve shown; other valve versions install in similar manner.
•
If supplies will be run “thru-wall”, Bradley recommends using a 90° street ell to connect the supply hoses.
•
If supplies will be run “from above”, Bradley recommends running them approximately 1/2" into the top cover.
See table on page 2 for recommended
showerhead heights.
2
Install Shower
Shower Dimensions
Front
Rear
Hot
Cold
or
Tempered
Supplies
Thru
Wall
6-3/4"
(173)
4"
(102)
1/2"
(13)
5"
(127)
6"
(152)
4"
(102)
13-3/4"
(349)
3-1/8"
(80)
Supplies from above
22-3/4"
(579)
3-1/4"
(82)
1/2"
(12)
17-3/4"
(452)
6-7/8"
(173)
1/2"
(12)
1-3/4"
(44)
3-1/2"
(89)
16-3/4"
(425)
Using the shower hinge as a
template, mark wall and drill
holes for 1/4" fasteners (wall
anchors and fasteners
supplied by installer). Secure
hinge side to the wall.
A
Connect the 1/2" flexible hoses
to the supply lines. Turn the
water on and check for leaks
and adequate water spray.
B
Close the shower tight to
the wall and mark the
holes for the mounting
tabs on the wall. mark wall
and drill holes for 1/4"
fasteners. Secure tabs to
the wall.
C