Sharp R-222STWE Four à micro-ondes solo - Manual (Page 234)

GB-15
BEFORE OPERATION
SETTING THE CLOCK
Plug in the oven. The oven display will display: “0:00”, an audible signal will sound once.
This model has a clock function and the oven uses less than 1.0W in stand by mode.
To set the clock, see below.
Your oven has a 24 hour clock feature.
1. Press the CLOCK/KITCHEN TIMER button once. The hour fi gure will fl ash and the clock
indicator will illuminate.
2. Rotate the ENTRY dial until the correct hour is displayed, the input time should be
within 0-23.
3. Press the CLOCK/KITCHEN TIMER button, the minute fi gure will fl ash.
4. Set the minutes. Rotate the ENTRY dial until the correct minutes are displayed, the input
time should be within 0-59.
5. Press the CLOCK/KITCHEN TIMER button to start the clock. The icon “:” of the digital
time will be fl ashing on the display and the clock indicator will disappear.
NOTES:
• If the clock is set, when cooking is complete, the display will show the correct time of
day. If the clock has not been set, the display will show "0:00".
• To check the time of day during a cooking process, press CLOCK/KITCHEN TIMER
button and the LED will display the time of day for 2-3 seconds. This does not aff ect the
cooking process.
• If in the process of setting the clock, the STOP/CLEAR button is pressed, the oven will
revert back to the former setting.
• If the electrical power supply to your microwave oven is interrupted, the display will
intermittently show "0:00" after the power is reinstated. If this occurs during cooking, the
programme will be erased. As will the time of day.
KITCHEN TIMER FUNCTION
You can use the kitchen timer function in instances where microwave cooking is not in-
volved for example to time boiled eggs cooked on conventional hob or to monitor the
standing time for cooked/defrosted food.
Example:
To set the timer for 5 minutes.
1. Press CLOCK/
KITCHEN
TIMER twice.
2. Rotate
ENTRY dial to
select time.
3. Press the START/
+30sec./ENTER
key to start the
timer.
4. Check the display.
(The display will count
down through the
programmed time.)
When the timer arrives at 0:00, an audible signal will sound 5 times and the LED will then
display the time of day.