Bissell PROHEAT2X 8920 - Manual (Page 19)

16
Troubleshooting
Built-in Heater Ready Light does not illuminate.
Possible Causes: Remedies:
The Heater Switch is not turned ON ( I ) Turn the Heater Switch ON ( I ).
The Power Switch is not turned ON ( I ) Both switches must be ON ( I ) to
activate the Heater Ready Light.
Reduced Spray or No Spray.
Possible Causes: Remedies:
Water Tank may be empty Fill Heavy Duty Bladder with hot
tap water.
Formula Tank may be empty Fill Formula Tank with BISSELL Fiber
Cleansing Formula for cleaning.
Tanks may not be seated completely Turn Power OFF ( O). Remove and
reseat tanks.
Pump may have lost prime Turn Power OFF ( O) and then back
ON ( I ). Wait one minute, then
depress Trigger.
DirtLifter PowerBrushes do not turn
Possible Causes: Remedies:
The Brush is off or broken Turn the machine OFF ( O) and unplug
from outlet. Follow instructions on
page 17.
The unit is in the upright position Brushes only rotate when unit is
reclined using the detent pedal.
Circuit Breaker may have tripped Turn the machine OFF ( O) and unplug
from outlet. Check to see if foreign
object is caught in brush roll. Remove
object. Plug machine back in to reset
circuit breaker.
Carpet Protector is not spraying
Possible Causes: Remedies:
Cartridge is not connected to the tool Follow instructions on cartridge to
assure proper fit.
Ready Tools Dial on Floor Setting Set Ready Tools Dial to Hose
Attachments Setting.
Solution clogging the Spray Trigger Soak Applicator Tool only in hot water.
Spray without the cartridge attached
to purge any residual solution left in
the tool.
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
1 1
2 2
1 1
2 2
3 3
4 4
1 1
1 1
2 2
3 3
19
2 2
3 3