Beko D 5001 EM - Manual (Page 7)

6 GB
3 Directions for Assembly
Safety notes for installation
Prior to installing and using your
appliance, please check it for possible
transit damage.
If the appliance is damaged, please
contact your supplier.
Never install or use a damaged
appliance.
The following directions must be
followed to connect the dishwasher
properly.
•
Before operating your dishwasher,
please ensure that the information
on the type plate corresponds to
the current and voltage of your
power supply.
•
The appliance may only be
connected using a properly
grounded socket. Ensure that the
appliance is grounded according
to regulations.
•
The grounded socket must be
easily accessible and close to the
appliance.
•
Do not use extension cables or
multiple adapters, as this can lead
to overheating, which can be a fire
hazard.
•
Hardwiring may only be carried out
by a qualified electrician.
•
Check the power cable, the
water inlet hose and the drainage
hose. Damaged parts may only
be replaced by customer service
personnel or by a qualified
electrical service expert.
Installing Your Dishwasher
•
Choose a suitable location for your
dishwasher. Take care to ensure
that the appliance is stable on a
level surface.
•
Unevenness in the floor can be
equalised by adjusting the screw
feet. When the appliance is
standing correctly, the door can be
closed without difficulty.
•
Water inlet and drainage hoses
must be positioned so that they
can move freely without bending
or squeezing.
•
The appliance may not be installed
in a room where the temperature
is below 0° Celsius.