Bloomfield Electric countertop griddles G-19 - Manual (Page 7)

5
INSTALLATION (continued)
WARNING: ELECTRIC SHOCK HAZARD
All servicing requiring access to non-insulated electrical components must be performed by a
factory authorized technician.
DO NOT open any access panel which requires the use of tools. Failure to follow this warning
can result in severe electrical shock.
CAUTION:
RISK OF
DAMAGE
DO NOT connect or energize
this appliance until all
installation instructions are
read and followed. Damage
to the appliance will result if
these instructions are not
followed.
CAUTION:
ELECTRICAL
SHOCK HAZARD
This griddle must be
electrically grounded.
Connect the terminal marked
“GND” or “ ”
to a suitable building ground.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
ELECTRICAL INSTALLATION
Refer to the nameplate. Verify the electrical service power. Voltage
and phase must match the nameplate specifications. Connecting the
griddle to the wrong voltage can severely damage the unit or cause
noticeably decreased performance.
IMPORTANT: Damage due to being connected to the wrong voltage is
NOT covered by warranty.
Use copper wire suitable for at least 90ºC for supply connections.
Griddles are factory wired three-phase (3ø).
For single-phase (1ø) wiring, refer to the wiring diagram attached to the
griddle.
This griddle is not fused. Protect the circuit with properly sized fuses or
circuit breaker.
An electrical disconnect must be installed readily accessible to the
operator of the griddle.
EQUIPMENT SETUP
Install splashguard. Notches on front wings lock into exposed studs in
grease trough.
Slide grease drawer into grease drawer sleeve in front of griddle.
101
p/n
3033
39
OpM
anual Counter
top Ele
c
tric Gri
ddle
s