Beko WME 8227 W - Manual (Page 18)

EN 18
• Spin+Drain
This program is used to apply an
additional spin cycle for the laundry or to
drain the water in the machine.
Before starting this program, select the
desired spin sped and press “Start/
Pause/Cancel” button. Your machine
drains the water after spinning at the set
spin speed.
If you only want to drain the water
without spinning your laundry, select
“Spin and drain” program, and then
select no spin function with spin speed
selection button. Press “Start/Pause/
Cancel” button.
A You should use a lower spin speed
for delicate laundries.
Temperature selection
Whenever a new programme is
selected, the temperature anticipated
for that programme appears on the
temperature indicator (2b).
To change the temperature, press
the temperature button (Figure 1-3).
Temperature falls with 10° decrements.
Cold selection is shown with “-” symbol.
When the “Temperature” button is
pressed after coming to the Cold
selection, the maximum temperature of
the programme you have selected will
be displayed.
To decrease the temperature, press the
“Temperature” button again.
90˚C
Normally soiled, white cottons
and linens. (Ex.: coffee table
covers, tablecloths, towels, bed
sheets)
60˚C
Normally soiled, fade proof
colored linens, cottons or
synthetic clothes (Ex.: shirts,
nightgowns, pajamas) and
lightly soiled white linen clothes
(Ex.: underwear)
40˚C
30°C
Cold
For delicate clothes (Ex.: veil
curtains), blended clothes
including synthetics and
woolens.
Spin Speed selection
Whenever a new programme is
selected, the maximum spin speed of
the selected programme is displayed on
the spin speed indicator (Figure 2-2a).
To decrease the spin speed, press
the “Spin” button (Figure 1-1). Spin
speed decreases gradually. Then, rinse
hold and no spin options are shown
respectively.
Rinse hold is shown with “
” and no
spin is shown with “ ” symbols.
If you do not want to unload your
clothes immediately after the
programme, you may use the rinse hold
function in order to prevent your clothes
become wrinkled in an anhydrous
condition. With this function, your
laundry is kept in the final rinsing water.
If you want to spin your laundry after the
rinse hold function:
- Adjust the spin speed.
- Press Start/Pause/Cancel Button.
Programme resumes. Your
machines drains the water and
spins your laundry.
You can use no spin function in order to
drain the water without spinning at the
end of the programme.
e