Nokia Bluetooth Speakers MD-5W - Manual (Page 5)

ENGLISH
Warning: Use only chargers
approved by Nokia for use
with this particular device.
The use of any other types may invalidate
any approval or warranty and may be
dangerous.
When you disconnect the power cord of
any enhancement, grasp and pull the
plug, not the cord.
Connect to power
The speakers can be powered by four
AA batteries or the supplied charger.
Install AA batteries
When you use batteries, alkaline
batteries are recommended. To install
the batteries, ensure that the speakers
are off, and open the cover of the
battery compartment by pushing the
lower part of the cover and pulling the
cover up.
Place the batteries as indicated in the
compartment, and push the cover
until it snaps into place.
During long periods where the
speakers are not used, remove the
batteries to prevent damage from
battery leakage.
When battery power falls low, the red
indicator light starts to flash and the
speakers beep once a minute.
Connect to wall outlet
To use the speakers with the charger,
connect the charger to a wall outlet,
and plug the charger cable to the
power connector.
If rechargeable batteries are placed in
the battery compartment, they are not
charged by the charger.