BT 120 - Manual (Page 5)

4
Wall-
mounting
Your Converse 120 can
be wall-mounted using
the screws and wall plugs
provided.
Before you wall-mount your
Converse 120, check that:
• the wall can support
the weight of the phone;
• the position you choose
leaves sufficient space
so that the phone is
clear of any obstruction
on the wall, such as a
shelf or cupboard.
Unclip the stand on the
back of the Converse 120.
Drill two holes in the wall
61mm vertically apart
using an 8mm drill bit.
Insert the wall plugs if
necessary, then insert
the screws leaving about
5mm protruding from
the wall on which to
hang the phone.
Rotate the handset hook
180˚ so that it protrudes
upward. This holds the
handset in place when
wall mounted.
Hang the holes on the
back of the phone over
the screwheads and
gently pull the phone
downward to make sure
it is securely in place.
Hang the handset on the
handset hook.
1
2
3
5
6
Help
No dialling tone
Is the line cord plugged
into the telephone
socket?
Nothing happens
when you dial
Check that the dialling
mode switch is set to the
correct position.
The handset does
not ring
Is the ringer volume set
to
OFF ?
You may have too many
phones, fax machines
and/or answering
machines plugged in
which might be
overloading the sockets.
(See ‘Ringer Equivalence
Number’, back page).
WALL
WALL PLUG SCREW
61mm
4