beautypg.com

Optional) -8, Starting and ending the bios setup program – Toshiba Satellite Pro U200 User Manual

Page 144

background image

7-8

User’s Manual

HW Setup

Configuring the Execute-Disable Bit Capability and

TPM (optional)

The configurations for the Execute-Disable Bit Capability and TPM are

carried out in the BIOS setup program.
These functions are provided with some models.

Starting and Ending the BIOS Setup Program

Starting the BIOS Setup Program

1. Switch on your computer while pressing the Esc key.

If “Password =” is displayed, enter either the Supervisor Password, if

one is set, or the User Password and press the Enter key.

Please refer to Chapter 6, the

TOSHIBA Password Utility

, for details

about the User Password.

The “Check system. Then press [F1] key.” message is

displayed.

2. Press the F1 key.

The BIOS setup program will start up.

Notes before using the BIOS Setup

In most cases, changes to the system’s configuration should be made

within Windows by using applications such as TOSHIBA HW Setup,

TOSHIBA Password Utility, TOSHIBA Power Saver, Windows

Device Manager and so forth. If you make changes to the

configuration through the BIOS setup program, please be aware that

the configuration set through the Windows applications will take priority.

Changes to the settings within the BIOS setup program will not be

erased even if the power supply is switched off and the main battery

removed. However, if the built-in Real Time Clock (RTC) battery runs

out of power, most of the settings will revert back to their default values.

However, please note that the following items will not be affected in this

instance:

• Password

• Hard Disk Drive Password

• Security controller

Fingerprint patterns

Select either the Execute-Disable Bit Capability or settings in the security

controller to make changes. Please refer to the operating instructions

displayed in the settings screen.