beautypg.com

Finishing your fireplace (zc), Clearances (zc) – New Buck Corporation 34 User Manual

Page 35

background image

FINISHING YOUR FIREPLACE (ZC)

There is a wide variety of finishing material
available for your fireplace from formal
wall treatments with marble and mantels, to
rustic wood paneling, stone or brick. Non-
combustible materials used in this
installation such as slate, tile, marble, etc.
must be at least 1/2" thick.

IT IS IMPORTANT THAT THE BLACK FACE
OF THE FIREPLACE NOT BE COVERED
WITH ANY TYPE OF COMBUSTIBLE
MATERIAL.

Check to see whether man-made brick and
stone are made of non-combustible
materials before using them on the face of
the fireplace. Some of these products

contain combustible materials. Combustible
wall coverings such as paneling or wall-
board may not overlap the black face of the
fireplace. The space between the wall
covering and the fireplace should be sealed
with a heat resistant material such as rock
wool insulation or mortar.
NOTE: An “L” shaped steel lintel must be
installed across the top of the firebox
opening where facing materials such as
brick or stone is used on the face of the
firebox. It acts as a support/firestop. It
should be attached to the face of the
fireplace with screws and sealed to the
fireplace with a heat-resistant sealer.

CLEARANCES (ZC)

To ensure a safe installation, the following
must be carefully observed.
1. Sidewall Clearances: Clearances from
the side of the fireplace opening to any
adjacent combustible wall should not be
less than 7".
2. Ceiling Clearances: The ceiling height
should not be less than 24" from the top of
the fireplace opening.

3. Mantel Clearances: Clearance from top
of heater to mantel or mantel supports
should not be less than 20".
4. Floor Clearances: No clearance is
required if the appliance is installed per
these instructions.

24" MIN.

CLEARANCE

TO CEILING

7" MIN.

CLEARANCE

TO SIDE WALL

SIDE WALL

20” MIN. CLEARANCE TO
MANTEL OR SUPPORTS

33