Behringer F-Control Audio FCA202 - Manual (Page 9)

9 F-CONTROL AUDIO FCA202 User Manual
• When the installation has been successfully completed,
connect the hardware interface with the computer via an
unused FireWire socket. The hardware inputs and outputs
are now available to you in every audio application
◊ During the installation process, you may be given a
Windows message that the equipment drivers that
are to be installed have not passed the Windows
Logo test. Confirm this message and proceed as usual
with the installation. Your Windows installation will
not be affected by this in any way
2.3 Installation under Mac OS X
With the Mac OS X, you can use the FCA202 immediately,
without having to install additional drivers. Connect the
hardware to your Mac via an unused FireWire socket.
OS X (from version 10.3.9) will automatically recognize the
equipment. The inputs and outputs on the interface are now
available to you in every audio application.
2.4 Hardware connection
Connect the FCA202 to your computer using one of the two
FireWire cables provided. Some computers have 6-pin sockets
which allow the power supply for the FireWire hardware to
be made directly via the bus, while others offer reduced 4-pin
sockets. Depending on the arrangement, there are various ways
in which you can operate your FCA202.
• Operation without a mains adapter on a computer
with a 6-pin socket
This is a typical setup for most computers, which can
provide adequate power supply for the FCA202 via the
FireWire interface. Use the appropriate cable with the
6-pin plug connectors. If your computer cannot ensure
an adequate power supply, use the mains adapter that
is provided.