Behringer Studio Condenser Microphone C-1 - Manual (Page 3)

3 C-1 User Manual
1. Power Supply
Your condenser mic C-1 needs a phantom power supply (+36 to +52 V). If your C-1 is
connected to a microphone preamp and supplied with phantom power, the LED on the
microphone lights up. BEHRINGER assumes no liability for any damage caused by a
defective phantom power supply. Always mute the sound reinforcement system before
you switch on the phantom power supply.
2. Directivity
Your C-1 features a capsule with a cardioid pickup pattern and is ideal for recording
individual instruments, vocals and speech. Cardioid pickup pattern means that the sound
produced by sources located in front of the mic is strongly picked up. It is often used
in recording situations, since this directivity pattern tones down the pickup of sounds
located to the back of the microphone.
3. Microphone Installation
There is an adapter on your microphone that lets you mount it on mic stands with
either metric (Europe) or imperial-gauge threads (North America). First dismantle the
microphone from the stand mount adapter by detaching the fine-thread shoulder screw
at the bottom end of the microphone. Fasten the adapter onto the microphone stand,
place the microphone into it and tighten the screw again.
Basically, the microphone in the stand mount adapter should stand upright and face the
sound source at a right angle. The angle of the microphone to the sound source influences
the sound of the recording; therefore, experiment with different positions until you
achieve the desired sound. To this end, you can rotate the mic in the stand mount adapter
by loosening the screw somewhat and tightening it again.