beautypg.com

Operation – Broilmaster SBG2801-1 User Manual

Page 16

background image

SBB00095-2-0407

Page 16

OPERATION

Checking for Gas Leaks
Check for gas leaks every time you connect your Superb by

Broilmaster

®

propane gas grill to a Propane gas cylinder, when a

connected cylinder has not been used recently, or when either a

natural or propane grill is being used for the first time.
Caution: Do not use a flame when checking for leaks. Checking

for leaks with a flame may lead to a fire or explosion, resulting

in property damage or personal injury.
To check for gas leaks:

1. Use dish washing liquid and a little water to make a soapy

solution.

2. Turn OFF the knobs on the control panel.

3. Turn ON the gas at the supply or cylinder. A hissing sound

indicates a leak. Turn OFF the gas and repair the leak.

4. Apply the soapy water solution to all gas connections.

5. Look for bubbles. Bubbles indicate a leak.

6. If there are bubbles turn OFF the gas and repair the leak.

7. Turn the gas back ON and repeat the above procedures until

all leaks are repaired.

Air Shutter Adjustment
1. Remove cooking grids and flame tamers from grill.

2. Ignite burners on grill and observe flame pattern. If flame is

yellow in color or flame is lifting off burner the air shutter on

burner will require adjustment.

3. Turn gas OFF and allow the grill to cool.

4. Loosen two (2) Phillips screws at end of each burner. Lift

upward and pivot burner out of grill.

5. Loosen Phillips screw at air shutter. Open air shutter for a

yellow flame or close air shutter for a lifting flame. Tighten

Phillips screw at air shutter.

6. Replace burners into grill. Tighten two (2) Phillips screws at

end of each burner.

7. Ignite burners on grill to verify burner flame characteristics.

OPERATING INSTRUCTIONS

Using the Ignitor
Caution: If a burner fails to light after 5 seconds, turn the

burner OFF for 5 minutes, to allow the gas to clear, then try

again.
Attention:
You should use the center burner(s) to ignite the first

burner, then move from center to both sides.
Attention: The control knob that is second from left side of grill

is for the rotisserie. See Rotisserie Operation on page 12.
1. Turn the right control knob clockwise

to the OFF

position.

2. Turn ON gas supply to the grill.

3. With the grill lid open, push and turn the right control knob

counterclockwise

to HI.

4. Push and hold in the ignitor button until the right burner ig-

nites.

5. If right burner does not ignite, turn right control knob clockwise

to the OFF position. Turn OFF gas supply to grill.

Refer to Troubleshooting section in this manual.

OPERATING INSTRUCTIONS

Using Matches
Caution: If a burner fails to light after 5 seconds, turn the

burner OFF for 5 minutes, to allow the gas to clear, then try

again.
Attention:
You must use the control knob on the right side of the

grill to ignite the first burner. The second burner to be ignited will

be the second from right side of grill and so forth, always moving

from right to left.
Attention: The control knob that is second from left side of grill is

for the rotisserie. See Rotisserie Operation on page 12.

1. Turn the right control knob clockwise

to the OFF

position.

2. Turn ON gas supply to the grill.

3. Open the grill lid.

4. A match holder is attached on the inside of the right door. Place

a match into match holder. Insert burning match through the

lighter hole on right cart side. Place burning match adjacent

to right burner.

Figure 19

5. Push and turn the right control knob counterclockwise

to HI.

6. If right burner does not ignite, turn right control knob clockwise

to the OFF position. Turn OFF gas supply to grill.

Refer to Troubleshooting section in this manual.