Cabinet and stand maintenance, Specifications – Pioneer CP-2EX User Manual

Page 4

Assembly with a separate speaker system

If you are using a speaker system other than the S-2EX, note
that you will have to use a hand drill (or the like) to make
holes on the speaker base to secure it to the stand. Make
sure the speaker weight does not exceed 29 kg.

After making holes on the speaker base where indicated
(make sure they line up with the screw holes on the speaker
support), secure the speaker to the speaker support using
commercially available wood screws as shown below.

Speaker
base

Speaker
support

Fastening nut

Commercially
available wood
screw

Screw holes
for securing
speaker

Cabinet and stand maintenance

• Use a polishing cloth or dry cloth to wipe off dust and

dirt.

• If the cabinet or stand is very dirty, use a soft cloth

dipped in some neutral cleanser diluted 5 or 6 times
with water. Finally, wipe again using a dry cloth. Do not
use furniture wax or cleaners.

• Never use thinners, benzine, insecticide sprays and

other chemicals on or near the cabinet or stand, since
these will corrode the surfaces.

Specifications

External dimensions ............... 400 (W) x 604 (H) x 513 (D) mm
Weight .............................................................................. 17.8 kg

Supplied accessories

Stand base plates ...................................................................... 2
Speaker supports ....................................................................... 2
Stems .......................................................................................... 4
Spikes (with attached nuts) [SBA6053] ................................... 8
Spike bases [SLA1057] .............................................................. 8
Screws (Bind head, M5xL62) [SBA6050] ................................. 4
Screws (Bind head, M5xL36) [SBA6048] ................................. 4
Screws (Bind head, M6xL40) [SBA6054] ............................... 24
Spring washers [SBE6005] ........................................................ 4
Washers [SBE6006] ................................................................... 4
These operating instructions [SRD6045] ................................. 1

• Specifications and design subject to possible modifica-

tion without notice, due to improvements.

• The product number are listed above in square brackets.

If you want to dispose this product, do not mix it with
general household waste. There is a separate collection
system for used electronic products in accordance with
legislation that requires proper treatment, recovery and
recycling.

Private households in the 25 member states of the EU, in
Switzerland and Norway may return their used electronic
products free of charge to designated collection facilities or to a
retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local
authorities for the correct method of disposal.

By doing so you will ensure that your disposed product under-
goes the necessary treatment, recovery and recycling and thus
prevent potential negative effects on the environment and
human health.

Part name
• Protector (Bottom)
• Protector (Middle)
• Protector (Top)
• Protector
• Packing case
• Protection sheet
• Protection sheet
• Protection sheet

Part no.
SHA6095
SHA6096
SHA6097
SHA6098
SHG6150
SHC6044
SHC6045
SHC6046

Replacement part numbers

Published by Pioneer Corporation.