Removing the front panel 7, Attaching the front panel 7, Switching the dsp setting mode 7 – Pioneer DEH-P9600MP User Manual

Page 7: Switching the dsp setting mode, Before you start

! When removing the front panel, be sure to

hold the corrugated release button on the rear
of the front panel while pulling.

Removing the front panel

1 Press OPEN to open the front panel.

2 Slide and remove the front panel to-

ward you.

Take care not to grip it too tightly or to drop it.

Release button

3 Put the front panel into the protective

case provided for safe keeping.

Attaching the front panel

1 Make sure the inner cover is closed.

2 Replace the front panel by clipping it

into place.

Switching the DSP setting

mode

This unit features two operation modes: the 3-

way network mode (NW) and the standard

mode (STD). You can switch between modes

as desired. Initially, the DSP setting is set to

the standard mode (STD).

! After switching, reset the microprocessor.

Before You Start

English

Section