Pioneer AVH-P7500DVD - Manual (Page 2)

1
Contents
Connecting the Units ................................ 1
Connecting the system ...................................... 3
Connecting the power cord (1) .......................... 4
Connecting the power cord (2) .......................... 5
When connecting to separately sold power
amp ............................................................ 7
When connecting with a back-up camera ........ 9
When connecting the external video
component and the display ...................... 10
Attaching the noise filters .............................. 11
Installation ................................................ 12
Installing the hide-away unit .......................... 13
DIN Front/Rear-mount .................................... 13
DIN Front-mount ............................................ 14
DIN Rear-mount .............................................. 15
Fixing the front panel ...................................... 16
Installing the remote control unit .................... 16
CAUTION:
• PIONEER does not recommend that
you install or service your display your-
self. Installing or servicing the product
may expose you to risk of electric shock
or other hazards. Refer all installation
and servicing of your display to autho-
rized Pioneer service personnel.
• Secure all wiring with cable clamps or
electrical tape. Do not allow any bare
wiring to remain exposed.
• Do not drill a hole into the engine com-
partment to connect the yellow lead of
the unit to the vehicle battery. Engine
vibration may eventually cause the insu-
lation to fail at the point where the wire
passes from the passenger compartment
into the engine compartment. Take
extra care in securing the wire at this
point.
• It is extremely dangerous to allow the
display lead to become wound around
the steering column or gearshift. Be sure
to install the display in such a way that
it will not obstruct driving.
• Make sure that wires will not interfere
with moving parts of the vehicle, such as
the gearshift, parking brake or seat slid-
ing mechanism.
• Do not shorten any leads. If you do, the
protection circuit may fail to work
properly.
Connecting the Units