Pioneer CNSD-100FM - Manual (Page 5)

Preparation for upgrade
Checking the current version
You may need the version information to con-
firm completion of upgrade. Check the version
information using the following procedure.
1 Press the MENU button to display the
“Top Menu”, and then touch [Settings].
2 Touch [System Settings].
The
“System Settings” menu appears.
3 Touch [Service Information] on the
“System Settings” menu.
4 Write down the version displayed in
“Map Version” and “Version”.
Getting the password for
authentication
You need to input this password accurately.
Write down your password to avoid mistakes.
Upgrade procedures
This section describes the upgrade proce-
dures for your navigation system.
1 Park your vehicle in a safe place and
apply the handbrake.
2 Insert the upgrade SD memory card #2
into the SD card slot while the navigation
system is activated.
A message will appear asking whether or not
to start the upgrade.
p If the SD memory card #1 is inserted, eject
the card and insert the upgrade SD memory
card #2.
There is no need to turn the system off
when you replace the SD memory card #1
with #2.
3 Touch [OK].
p To cancel the upgrade, touch [Cancel].
4 Enter the password for authentication
that you obtained, then touch [Done].
After you touch [ Done], the system starts the
authentication. When the authentication is fin-
ished properly, a message for confirmation
will appear.
5 Touch [Yes] to start the upgrade.
The navigation system restarts and then the in-
stallation begins.
p To cancel the upgrade, touch [No].
The upgrade takes approximately 40 min-
utes in total.
When the programme upgrade is complete, a
confirmation message appears.
Instructions for upgrading
Engb
5
Chapter
02
Instructions
for
upgrading