Pioneer DEH-P800BT - Manual (Page 42)

2 Use MULTI-CONTROL to select
Auto answer.
3 Press MULTI-CONTROL to turn auto-
matic answering on.
# To turn automatic answering function off,
press
MULTI-CONTROL again.
Echo canceling and noise reduction
1 Display the function menu.
Refer to Introduction to advanced operations
on page 40.
2 Use MULTI-CONTROL to select
Echo cancel.
3 Push MULTI-CONTROL left or right to
select the desired setting.
OFF (off)
—LOW—MID—HIGH
# This function can be performed even while
talking on the phone. In this case, press
MULTI-CONTROL to switch to Echo cancel.
Switching the ring tone
1 Display the function menu.
Refer to Introduction to advanced operations
on page 40.
2 Use MULTI-CONTROL to select
Ring tone in the function menu.
3 Push MULTI-CONTROL left or right to
select the desired setting.
OFF (off)
—BEEP1—BEEP2—BEEP3
Making a call by entering
phone number
Important
Be sure to park your vehicle and apply the park-
ing brake when performing this operation.
1 Display the function menu.
Refer to Introduction to advanced operations
on page 40.
2 Use MULTI-CONTROL to select
Number dial.
# You can also press DIRECT on the remote con-
trol to enter in this menu from the standby dis-
play.
3 Push MULTI-CONTROL up or down to
select a number.
# You can also input numbers by pressing 0 to 9
on the remote control.
4 Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
# Up to 24 digits can be entered.
5 When you finish entering the number,
press MULTI-CONTROL.
Call confirmation appears.
6 Press MULTI-CONTROL again to make a
call.
7 To end the call, press .
Clearing memory
1 Display the function menu.
Refer to Introduction to advanced operations
on page 40.
2 Use MULTI-CONTROL to select
Clear memory.
3 Push MULTI-CONTROL up or down to
select an item.
Phone book (phone book)
—All clear (delete
all memory)
—Dial preset (preset phone num-
bers)
—Recent calls (call history)
# If you want to clear the entire Phone Book,
call history list and preset phone number, select
All clear.
4 Push MULTI-CONTROL right to deter-
mine the item that you want to delete
from this unit.
Clear memory YES is displayed. Clearing
memory is now on standby.
Operating this unit
En
42
Section
02