Black & Decker JC200 - Manual (Page 6)

Warning! Steam may escape from the
spout.
Warning! This kettle must only be used
with the kettle base provided.
Note: Ensure the lid is fitted correctly
before use.
Note: Disconnect the kettle from the power
supply before filling with water.
Note: Ensure the lid is correctly fitted
before use
Note: Allow the appliance to cool before
re-filling
• Place the kettle base (6) on a suitable
flat stable surface.
• Take the kettle to a water outlet.
• To open the lid, press the 2 buttons
together & lift. To avoid the danger of
burns, never do this when the water is
hot
• Fill the kettle with cold water to the
desired level.
• To prevent dry-boiling fill to at least 250
ml (one cup).
• Do not fill the kettle beyond the
maximum fill mark (4).
Warning! If the kettle is overfilled, boiling
water may be ejected from the spout.
• Close the lid (2) and make sure it snaps
into place.
• Place the kettle on the kettle base (6).
• Insert the plug into a suitable electrical
outlet and push the switch (1) to the on
position (I).
• The power on indicator (5) will light.
• The water will start boiling, making a
rumbling noise. Do not open the lid
when the water is boiling.
• As soon as the water has boiled, the
appliance will switch off and the power
on indicator (5) will go out.
• Always ensure the kettle has turned off
before lifting it from the kettle base.
• To switch the appliance off during boiling,
push the On / Off switch (1) the off
position (O).
• If you do not want to use the boiled water
immediately, the kettle may be left on the
base. If you want to bring the water back
to boil after a while, push the on / off
switch (1) to on again.
• The outer surface of the kettle may
become hot when in use
Pouring boiled water
Caution: Insure that the kettle is switched
off before removing it from its stand.
• Take the kettle off the base.
• To avoid scalding, tilt the kettle slowly to
pour the boiled water.
• After pouring, place the kettle back on
the base and remove the plug from the
socket.
Cleaning and maintenance
Warning! Before cleaning and maintenance,
switch the appliance off, remove the plug
from the socket and allow the appliance to
cool.
Warning! Do not immerse the appliance, the
base, the cord set or the plug in water or
any other liquid.
• Wipe the exterior with a damp cloth.
• Do not use scouring pads.
• If necessary, use a mild detergent to
remove spots.
• Do not use any abrasive or solvent based
cleaner.
• Do not immerse the kettle, base, cord or
plug in any liquid.
Technical Data:
English
-6-
JC200
Input voltage: 220-240V~
Power input: 1850-2200W
Weight: 1kg