Brother MFC-660CN - Manual (Page 21)

Installing the Driver & Software
19
Windows
®
W
ind
ow
s
®
Netw
o
rk
For Network Interface Users
(For Windows
®
98/98SE/Me/2000 Professional/XP/XP Professional
x64 Edition)
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on pages 4 through 13.
1
Disconnect the machine from the power
socket.
2
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
3
Connect the network cable to the LAN socket
marked with a
symbol. You will find the
LAN socket inside the machine on the left as
shown below.
4
Carefully guide the network cable into the
trench as shown below, following the trench
around and toward the back of the machine.
Then, connect the cable to your network.
Improper Setup
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both USB and LAN cables are being used, guide
both cables through the trench with one on top of
the other.
5
Lift the scanner cover to release the lock ( ).
Gently push the scanner cover support down
(
) and close the scanner cover ( ).
6
Turn on the machine by connecting the power
cord.