Olympus DP-20 - Manual (Page 3)

```
Recording
If the recorder is in recording mode and the REC (x) button is pressed,
recording pauses. If the REC (x) button is pressed again, recording resumes.
Inserting Batteries
Getting started
1
2
`
Battery indicator:
When [ ] appears on the display, replace the
batteries as soon as possible. When the batteries are too
weak, [ ] and [Battery Low] appears on the display
and the recorder shuts down.
Strap hole
• Strap is not supplied.
Microphone sensitivity
Turn the microphone in the direction of
the source to be recorded.
High
This is a highly sensitive
mode which can record
surrounding noises. (A H )
Low
This is the standard level of
microphone sensitivity. (A L )
a
b
c
d
e
f
g
• Recorder will not be able to record anymore when [Memory Full] or
[Maximum File Size is reached] appears. Delete any unnecessary
files before recording any further.
• When remaining recording time is less than 60 seconds, the
recording indicator light starts flashing. When the recording time is
decreasing to 30 or 10 seconds, the light flashes faster.
Recording indicator light is lit
while recording.
a Current date/ b Recording mode indicator/
c Microphone sensitivity indicator/ d Total
number of recorded files for the date/ e Current
file number/ f Elapsed recording time/ g
Remaining recording time
Turning off the power:
While the recorder is
in stop mode, slide the
POWER switch to the
[OFF/HOLD] position.
Power save mode:
If the recorder is on and
stops for 10 minutes or
longer, the display shuts
off and it goes into power
save mode. To exit power
save mode, press any
button.
HOLD:
If you slide the POWER switch to the [OFF/HOLD]
position, the current conditions will be preserved, and
all buttons and switches will be disabled.
• When you use this recorder for the first time after
purchasing, or when you switch it on after removing
the batteries for more than 30 minutes when
exchanging batteries etc, the time will return to the
default setting and the [Set Time & Date] will appear.
Turning on the power
Slide the POWER switch to the [ON] position.