Olympus EM5 - Manual (Page 103)

103 EN
Information
11
1
Select [Pixel Mapping] (P. 92) in c Custom Menu tab k.
2
Press I, then press Q.
• The [Busy] bar is displayed when pixel mapping is in progress. When pixel mapping
is finished, the menu is restored.
# Cautions
• If you accidentally turn the camera off during pixel mapping, start again from Step 1.
Card basics
Usable cards
In this manual, all storage devices are referred to as “cards.” The
following types of SD memory card (commercially available) can be
used with this camera: SD, SDHC, SDXC, and Eye-Fi. For the latest
information, please visit the Olympus website.
SD card write protect switch
The SD card body has a write protect switch. If you set the switch to
the “LOCK” side, you will not be able to write to the card, delete data or
format. Return the switch to the unlock position enable writing.
LOCK
# Cautions
• The data in the card will not be erased completely even after formatting the card or
deleting the data. When discarding, destroy the card to prevent leakage of personal
information.
• Use the Eye-Fi card in compliance with the laws and regulations of the country where the
camera is used.
• In locations such as on an airplane, where the Eye-Fi communication is prohibited,
remove the Eye-Fi card from the camera, or set [Eye-Fi] (P. 93) to [Off].
• The Eye-Fi card may became hot during use.
• When using an Eye-Fi card, the battery may run out faster.
• When using an Eye-Fi card, the camera may function more slowly.
Formatting the card
Cards formatted on a computer or other camera must be formatted with the camera
before they can be used.
All data stored on the card, including protected images, is erased when the card is
formatted. When formatting a used card, confirm there are no images that you still
want to keep on the card.
1
Select [Card Setup] in shooting menu W
(P. 111).
2
Select [Format].
3
Select [Yes] and press Q.
• Formatting is performed.
All Erase
Format
Card Setup
Back Set