Olympus PT-045 - Manual (Page 48)

EN 18
En
Seal the Case
1 Close the rear lid of the Case gently.
2 Turn the open/close dial clockwise.
• The Case is sealed when the dial is turned 180 degrees.
Check the operation of the loaded camera
After sealing the Case, check that the camera operations normally.
1 Push the ON/OFF button on the Case and confirm that the camera
turns ON/OFF.
2 Turn the mode dial on the Case and confirm that the camera mode
switches properly.
• Check if the correct mode is being switched from the LCD monitor.
3 Press the shutter lever on the Case and confirm that the camera
shutter releases.
• Also operate other control buttons on the Case and confirm that the
camera functions properly.
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This
will cause water leakage.
• Close the rear lid of the Case so that the lens cap or LCD hood strap
doesn’t catch. If it catches, water leaks may result.
Close
PT-045_EN.book Page 18 Monday, December 8, 2008 11:50 AM