Bosch MUM 6610 UC - Manual (Page 13)

13
2. If you have not already done so, move
the motor drive cover to the high-speed
drive. Place the mixing bowl on the drive
of the power unit and turn the bowl
counterclockwise with a slight
downward pressure until bowl is firmly
seated, see figure 4a.
CAUTION
Failure to make sure that the bowl is
properly seated on the drive coupling before
the power unit is turned on can result in
damage to the bowl and/or coupling.
3. Place and engage the twin beating
whisk assembly on the driveshaft of the
mixing bowl as shown in figure 6.
Figure 6.
4. Place the splash ring on the cover,
making sure the tabs on the bowl fit
into the recesses in the splash ring,
and turn counterclockwise, see figure
5a. Then place the cover on the splash
ring so that the tabs on the splash ring
fit into the recesses in the bowl cover
and turn the cover counterclockwise to
fasten the bowl cover to the bowl. See
figure 5b.
The splash ring and cover should be in
place whenever the power unit is in
operation. The splash ring and cover
serve to prevent the escape of flour
dust at the beginning of the stirring and
kneading process, and also serves to
prevent accidental contact with the
moving whisks.
Placing into Operation w/Twin Beating
Whisks
Make sure that the switch is in the off
position, “O/Off.” Unwind the electrical cord
to the necessary length and plug into the
wall outlet. The bowl with whisk assembly
is now ready for operation. See table 1 for
examples demonstrating the use of the twin
beating whisks.
Mixing bowl tips:
1. When using the mixing bowl to knead
or mix a recipe designed to be
prepared by hand, you will find that with
the Bosch Kitchen Machine you can
usually place all the ingredients in the
mixing bowl at once. When doing this,
always place the liquids in first. This
will assure more thorough mixing.
2. When adding ingredients to a mixture:
a. Turn the rotary switch to a lower
speed;
b. Remove the cover from the splash
ring;
c. Add the ingredients through the
cover opening and replace the
cover.
3. If a large batch of dough is to be left in
the mixing bowl and allowed to rise, the
cover and splash ring should be
removed and placed loosely on the bowl
so that it is free to move if the dough
should begin to press on it.