AEG F78420VI0P - Manual (Page 31)

Problem Possible solution
Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is
not clogged.
Make sure that the inlet hose has no kinks or
bends.
The appliance does not drain
the water. Make sure that the sink spigot is not clog-
ged.
Make sure that the drain hose has no kinks
or bends.
The anti-flood device is on. Close the water tap and contact the Service.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is
too much. Adjust the rinse aid selector
to a lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
penser and use rinse aid together with
the combi detergent tablets.
Refer to ‘HINTS AND TIPS’ for
other possible causes.
10.2 How to activate the rinse
aid dispenser
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
“Setting and starting a programme”.
2. Press and hold, at the same time,
button and button until the
indicators of buttons , and
start to flash.
3. Press button .
•
The indicators of buttons and
go off.
• The indicator of button
contin-
ues to flash.
• The display shows the current set-
ting.
Rinse aid dispenser off.
Rinse aid dispenser on.
4. Press button to change the set-
ting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
ENGLISH
31