AEG X59143MD0 - Manual (Page 3)

EN
Warning!!!
The remote control replicates the functions on the control panel supplied with the hood. For a clearer understanding
of these functions, please consult the instruction manual enclosed with the hood itself.
Avvertenze
• The remote control is powered by a 1.5 V carbon-zinc alkaline batteries of the
standard LR03-AAA type (not included).
• Do not place the remote control near to heat sources.
• Used batteries must be thrown in the battery bank.
Start up and dis-
connect the func-
tion Delay (where
the hood is pro-
vided for). Increases the
working speed. Turns the
suction mo-
tor on and
off. Decreases the
working speed. Start up / discon-
nect the motor to
the intensive speed
starting from each
speed (even with
switched off mo-
tor). Short pressure, switch
on /off lights up to the
highest brightness.
Long pressure, switch
on /off lights up to
soft light (where the
hood is provided for).
Activation process of remote control Receiver
Before carrying out any activation of the remote control it is necessary to verify the correct functioning of it.
In the case that of the activation is necessary, please follow the below instructions.
This activation should be carried out exclusively from the hood control panel.
PROCEDURE
• Switch off the light and the motor.
• Press the
key for about 5 seconds until on the display you can see IR and a Point that..:
• Flash twice, to indicate the ACTIVATION of the remote control receiver;
• Flash once, to indicate the DISCONNECTION of the remote control receiver;