Bosch sHe42l - Manual (Page 10)

1
Rinse Agent Dispenser
open the rinse agent dispenser by lifting the tab with your thumb as shown in
figure 17.
NOTE: the dishwasher indicates low rinse agent either by showing the symbol in the
countdown display, or illuminating the refill rinse agent light (model dependent).
add liquid rinse agent to the dispenser as shown in figure 18 until the rinse agent reservoir
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.
NOTE: After filling the rinse agent dispenser, the indicator light will go out in a few
minutes after the dishwasher door is shut (select models only).
Operating the Dishwasher
always make sure your dishware is dishwasher safe. refer to the Dishware Materials
section of this manual for guidance.
Wash Cycles (See Cycle Chart)
Power Scrub Plus
Cleans items having baked-on or hard dried-on food soils. these items may require soaking
or hand scouring.
Regular
thoroughly cleans large loads having loosely attached normal soiling.
Delicate/Economy
for delicate or heirloom dishwasher and silverware or other special items. always make
sure that the items are dishwasher safe. refer to the Materials section of this manual for
further information. Hand washing may be the best treatment of such items.
Quick Wash
for lightly soiled items with easy to remove food soils.
Rinse and Hold
allows you to rinse the food soil off of a partial load and hold them in the dishwasher until
there is a full load.
Wash Cycle Options
Half Load
in the power scrub plus, regular and auto Wash cycles you can reduce the energy and
water consumption when washing small, lightly soiled loads that fill approximately half of
the dishwasher’s capacity. to activate, select the Half load button in addition to the power
scrub plus, regular or auto Wash cycle button.
The Cycle Completion Signal (select models)
this Cycle Completion signal is a tone that sounds to alert you when your dishwasher
finishes washing and drying your dishes. You can either disable the tone or set the volume.
to activate:
· press and hold the right “Cancel Drain” button then press and hold the on/off button.
· When the light on the “Cancel Drain” button you are pressing illuminates and the tone
begins to sound, release both buttons.
· press the right-most “Cancel Drain” button until the tone is either at the desired
volume or is silent.
· press the on/off Button. the Cycle Completion signal is now set.
SHXL
SHXM
SHEL
SHXC
SHUA
SHEC
SHXA
SHEM
Half Load
Rinse and Hold
R
egular
Delicat
e/Econom
y
Po
w
er Scrub Plus
Quic
k W
ash
Wash Cycles
x x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x