AEG BSS 4810 - Manual (Page 59)

English
59
Maintenance and Cleaning
CAUTION:
Never immerse the unit in water!
• There are no parts inside the device which can be maintained by the user.
• Clean the speaker with a slightly damp cloth without cleaning agent.
Troubleshooting
Symptoms Possible cause Solution
Cannot switch the
speaker on Battery empty Charge the battery ( Page 54)
Audio cable is connected Disconnect the cable.
No audio signal during
Bluetooth connection Speaker is switched off Switch the speaker on.
Speaker is not paired to the
audio source. Check whether the connection
exists. If necessary, pair the speaker
to the audio source again.
Audio cable is connected. The Bluetooth connection is auto-
matically separated when a cable
is connected to the 3.5 mm plug.
Remove the cable.
Volume too low Increase the volume on the
speaker
Increase the volume on the audio
source.
Cannot connect
speaker Pairing does not work Check, whether the audio source
supports the A2DP protocol.
Audio source is turned off Turn the audio source on
Bluetooth is turned off on
the audio source. Turn the Bluetooth function on in
the audio source.
Bluetooth version is not sup-
ported. Use another playback unit.