Black & Decker BLACK AND DECKER CORDLESS HAND VAC PHV1810 - Manual (Page 3)

4 5
Assembly
Adjusting the dust collector
(fig. A - C)
The dust collector (1) has a brush that can
be folded forward for dusting and upholstery
cleaning.
• The dust collector (1) is stored under the
appliance. To adjust for use, unplug the
appliance from the charger (7).
• Press the pivot lock button (3) and rotate
the dust collector (1) to the required
position.
• Release the pivot lock button (3) to lock
the dust collector in position
• The dust collector can be extended by
pulling the dust collector extension (9) until it
locks into position.
• The extension can be retracted by
pressing the button (10) and pushing the
extension back into the dust collector.
• The dust collector should be returned to
the storage position under the appliance
after use and while charging the appliance.
Use
• Before first use, the battery must be charged for at least 24 hours.
• Plug the appliance into the charger whenever power gets low.
Charging the battery (fig. D)
• Make sure that the appliance is switched
off. The battery will not be charged with
the on/off switch (4) in the on position.
• Plug the appliance into the charger (7)
as shown. The charging indicator wil be lit.
• Leave the appliance on charge for at
least 24 hours.
While charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
The charging indicator will be lit as long as
the appliance is connected to the
plugged-in charger.
WARNING:
Do not charge the battery at ambient temperatures
below 39°F (4°C) or above 104°F (40°C).
Switching on and off (fig. E)
• To switch the appliance on, slide the
on/off switch (4) forward to position I.
• To switch the appliance off, slide the
on/off switch (4) back to position 0.
Optimizing the suction force
Rotating the bowl (fig. A) agitates the filter
to remove dirt; however, in order to keep
the suction force optimized, the dust
container and filters must be cleaned
regularly.
Cleaning the dust container and
filters (fig. F - K)
There are two methods of cleaning the
bowl, a quick empty method and a
thorough clean method.
For the quick empty method use the
following instructions.
• Press the release latch (6) and open the
container door (5) (fig. F).
• Empty the dust container (11).
• Close the dust container door (5). Make
sure that the release latch (6) clicks into
place.
For the thorough clean method use the
following instructions.
Product Features
1. Dust collector
2. Dust container release
button
3. Pivot lock button
4. On/off switch
5. Container door
6. Container door release latch
7. Charger
8. Flip-out brush
9. Dust collector extension
D
A
E
B
C
F
90560176 PHV1210 PHV1810.qxd:??????-00 Cir Saw book 1/18/10 9:49 AM Page 4