Britax P222000 User Manual

Page 8

Installation: ISOFIT

Connectors

Installation: ISOFIT

Connectors

IMPORTANT:

Before installing the

Expressway in your vehicle, make
sure that the shoulder slots are at
the correct level for your child.
See "Checking Harness Height"
on page 6).

Place the child seat, with har-

ness tightened, facing away from
you on the vehicle seat. (See
Figure A)

Loosely attach the furthest

ISOFIT connector to the LATCH
bar. (See Figure B) If unable to
make attachment, squeeze
release trigger, then try again.

Loosely connect tether strap to

tether anchor.

Rotate child seat into a forward

facing position.

Connect the second ISOFIT

connector to the LATCH bar.

IMPORTANT:

The ISOFIT straps

must be routed around the shell.
If the connections are made with
a direct route to the LATCH bars,
re-route the straps as shown in
Figure E, then continue.

With one hand, push the child

seat down into the vehicle seat
cushion, while pulling the each
ISOFIT connector strap tight. (See
Figure D)

Pull tether strap to tighten the

tether connection. (See Versa-
Tether on pages 18-19)

Verify that all connections are

tight and the child seat is secure.

To remove your Expressway

Loosen and unhook the tether

strap from the vehicle.

Loosen the ISOFIT straps by

pushing the adjuster tab on each
connector away from the child
seat.

Squeeze the red trigger to

release each ISOFIT connector.

LATCH Bars

Open

Closed