AEG X99464MK2 - Manual (Page 5)

5 ENGLISH
5. CONTROLS
The hood is fi tted with a control panel with
aspiration speed selection control and a
light switch to control cooking area lights.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
The control switches are located on the
unit’s front panel.
Note: a remote control can be purchased
apart, contact the local authorized dealer.
1 2 3 4 5 6
1 ON/OFF suction speed 1
2 ON/OFF suction speed 2
3 ON/OFF suction speed 3
4 ON/OFF Suction speed boost: press
to select boost suction speed, this lasts
for 5 mins then hood set suction speed
3.
5 Delayed OFF function: press to
select suction speed 1, after 15 minutes
suction speed switch OFF.
6 ON/OFF lights
Note: Press and keep pressed to adjust
light intensity.
Caution! Do not look directly into
the LED light.
Grease Filter saturation indicator
Perform grease fi lter maintenance as the
button
5 blinks.
Reset of the Grease Filter saturation
indicator
Press button
5 for more than 5 secs.
6. LIGHTING
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
Caution! Do not look directly into the
LED light.
For replacement, contact the technical
service.