AEG A92700GNW0 - Manual (Page 34)

2 1
• Remove the door closure device on
the door.
• Re-screw the door closure device pro-
vided within the accessory bag on the
opposite side.
2 1
• Remove the door.
• Unscrew and move the pin to the op-
posite side.
• Re-insert the door.
• Re-screw the lower hinge.
• Raise the appliance and install the
ventilation grille.
180°
• Unscrew the handle. On the opposite
side remove the hole covers by driving
a 3-4 mm drift or drill into them.
• Install the handle. Fit the handle on to
the opposite side by turning it on half
circle.
• Install the hole covers provided within
the accessory bag.
• Put the cabinet in position.
WARNING!
Reposition, level the appliance,
wait for at least four hours and
then connect it to the power
socket.
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to
the side edge of the appliance.
• The magnetic seal adheres to the cab-
inet.
• The door opens and closes correctly.
WARNING!
If the ambient temperature is
cold (i.e. in Winter), the gasket
may not fit perfectly to the cabi-
net. In that case, wait for the nat-
ural fitting of the gasket.
8. NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
34 www.aeg.com