Brinkmann Heavy-Duty 4905 - Manual (Page 13)

12
MATCH LIGHTING THE SIDE BURNER:
1. Remove the lid to the side burner before lighting.
2. Make sure control knob is in the "OFF" position.
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.
4. Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See "Trouble Shooting" section of this manual.
TURNING OFF THE GRILL:
1. Turn off the cylinder valve.
2. Turn all burner control knobs to the "OFF" position.
NOTE: Turn off LP cylinder first to prevent gas from being left in the system under pressure.
CAUTION!
• The cylinder valve should always be in the off,
or closed, position when the grill is not in use.
To turn off the cylinder valve,
turn knob clockwise until it stops.
NOTE: Observe flame height when lit: Flame
should be a Blue/Yellow color between
1"– 2" when burner is on
" HIGH”.
2"
1"
0"
IM PO RT AN T S AFE GU AR D
• DO NOT REM OVE THIS TAG •
TUR N G AS O N A ND O FF
USIN GVA LVE ON L.P . GA S
TAN K. U SE T HIS RE D
CO NTR OL V ALV E FO R
FLA ME A DJU STM ENT ON LY.