Adding and registering handsets – AT&T TL96371 User Manual
Page 13

Registration and deregistration
9
Adding and registering handsets
Register a handset to your telephone base
(for AT&T models TL96271/TL96371/TL96471)
1. Make sure the handset is out of the telephone
base or charger and shows
Put handset on
�ASE to register before you begin registration.
2.
Put the handset you wish to register on the
telephone base cradle, not the charger.
3.
The handset displays Registering handset...,
and the telephone base screen displays
Registering... Please wait. It takes about 90
seconds to complete the registration process.
The handset displays
�ANDSET X Registered
(
X represents the registered handset number),
and beeps when registration completes.
If registration fails, the system will
automatically try to register again. If it fails
after the third try, the handset displays
Registration failed, then Put handset on
�ASE to register. The telephone base screen
displays
Registration failed and then returns
to the idle screen. This may take up to five
minutes to occur. When the handset displays
Put handset on �ASE to register, please start
again from Step 1 above.
NOTES:
You cannot register a handset if any other system
handset is in use.
Registration slots are full shows on the base
screen while you are doing Step 3 above.
•
•
Put Handset
on BASE
to register
Registering
handset...
Registering...
Please wait
HANDSET X
registered
HANDSET X
registered