AEG F34500VI0 - Manual (Page 25)

7.1 Using the detergent
20
30
M AX
1 2 3
4
+ -
A B
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
7.2 Using the combi detergent
tablets
When you use tablets, that contain salt
and rinse aid, do not fill the salt contain-
er and the rinse aid dispenser. The rinse
aid indicator always comes on if the rinse
aid dispenser is empty.
1. Adjust the water softener to the low-
est level.
2. Set the rinse aid dispenser to the
lowest position.
If you stop to use the combi
detergent tablets, before you
start to use separately
detergent, rinse aid and
dishwasher salt, do these
steps:
1. Press the on/off button to activate
the appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the released quantity of rinse
aid.
7.3 Setting and starting a
programme
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation, all the programme
indicators are off and the end indicator
flashes.
If the control panel shows other condi-
tions, press and hold the programme
button until the appliance is in setting
mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Press continuously the programme
button until the indicator of the pro-
gramme you want to set comes on.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button to delay the
start of the programme of 3 hours.
The delay indicator comes on.
3. Close the appliance door. The count-
down starts.
ENGLISH
25