AEG HC452020EB - Manual (Page 16)

Cookware made of enamelled
steel and with aluminium or
copper bottoms can cause the
colour change on the glass-
ceramic surface.
5.2 Energy saving
• If it is possible, always put the lids on
the cookware.
• Put cookware on a cooking zone
before you start it.
• Use the residual heat to keep the
food warm or to melt it.
• The bottom of the pans and cooking
zones must have the same dimension.
6. CARE AND CLEANING
WARNING!
Refer to Safety chapters.
6.1 General information
• Clean the hob after each use.
• Always use cookware with clean
bottom.
• Scratches or dark stains on the surface
have no effect on how the hob
operates.
• Use a special scraper for the glass.
• Use a special cleaner applicable for
the surface of the hob.
6.2 Cleaning of the hob
• Remove immediately: melted plastic,
plastic foil, and food with sugar. If not,
the dirt can cause damage to the hob.
Put the special scraper on the glass
surface at an acute angle and move
the blade on the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
some detergent. After cleaning, rub
the hob dry with a soft cloth.
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem Possible cause Remedy
You cannot activate or oper-
ate the hob. The fuse is released. Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Residual heat indicator does
not come on. The zone is not hot because
it operated only for a short
time. If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
www.aeg.com 16